top of page

How To Roll a REAL Hemp Wrap



Intro:

Hemp leaf wraps have become increasingly popular, and for good reason - they provide a smooth and flavorful smoking experience while being made from sustainable materials. In this tutorial, we will show you how to roll a hemp leaf wrap from Native Leaf Co, step by step.



Materials Needed:

Rolling tray
Grinder
Lighter
Hemp wrap from Native Leaf Co.
Hemp wick
Cardboard filters
Plant glue
Leaf patch
Make sure you have everything on hand before you begin.


Instructions:


Step 1: Hydrate Hemp Leaf in Warm Water

The first step to rolling a hemp leaf wrap is to hydrate the leaf. To do this, soak the hemp leaf in warm water for a few minutes until it becomes pliable. This will make it easier to roll and prevent the leaf from cracking.


Step 2: Grind Weed

While the hemp leaf is hydrating, grind up your weed using a grinder. Make sure the consistency is even and not too fine, as this can cause the joint to burn too quickly.


Step 3: Roll Filter Tip

Next, roll a filter tip using the cardboard filter provided by Native Leaf Co. This will prevent weed from getting in your mouth while smoking and improve airflow. Make sure to roll the filter tightly and insert it into one end of the hemp leaf.


Step 4: Dry off Hemp Leaf

Once the hemp leaf is hydrated, dry it off with a paper towel to remove any excess water. You want the leaf to be damp, but not too wet, or it will be difficult to roll.


Step 5: Add Weed, Tuck & Roll

Now it's time to add the weed to the hemp leaf. Sprinkle the ground-up weed onto the leaf, making sure to spread it evenly. Then, use your fingers to tuck and roll the leaf, shaping it into a joint. Make sure to keep the joint tight, as this will improve airflow and prevent the joint from running.


Step 6: Use Plant Glue to Seal

To seal the joint, use the plant glue provided by Native Leaf Co. Apply a small amount of glue to the edge of the leaf and press it down to seal. Make sure to apply enough pressure to ensure a tight seal.


Step 7: Dry Hemp Wrap with Lit Hemp Wick

Once the joint is sealed, it's time to dry the hemp wrap. Use the hemp wick provided by Native Leaf Co. to light the joint and hold it over a flame. This will dry the wrap and remove any excess moisture.


Step 8: Light Hemp Wrap Evenly All the Way Around

Finally, it's time to light up and enjoy your hemp leaf wrap. Use a lighter to evenly light the hemp wrap all the way around. Take slow and steady puffs to prevent the joint from running or burning too quickly.


Conclusion:

Rolling a hemp leaf wrap can seem intimidating at first, but with practice and patience, anyone can do it. By following the steps outlined in this tutorial, you can enjoy a natural and eco-friendly smoking experience that will elevate your cannabis consumption. With the right materials and technique, you can create a smooth and flavorful joint that you'll be proud to share with your friends. So grab your rolling tray, grinder, and hemp wrap from Native Leaf Co, and let's get rolling!




Our sponsor helped make this content possible, and we want to give them a big thank you for their support. Check them out here: https://nativeleafco.com/

Comments


bottom of page